Wall Stickers Installation

No-sweat application! Just peel the wall stickers off the sheet
and place them on the wall. A word to the wise: remember to
keep the backing paper so that you have a place to store your
wall stickers when you want to take them off.
PEEL & STICK WALL STICKERS INSTALLATION
Wall stickers
Before you begin!
The DO’s
Apply on nished surfaces only (i.e. primed and painted walls).
Apply to room temperature surfaces (~68 degrees F, or 20 degrees C).
Wait at least two weeks before applying to newly painted walls.
Wash and completely dry your hands before application.
After applying each sticker, smooth over entire area with
pressure, paying special attention to the edges.
The DONTs
Do not apply to unnished surfaces (i.e. bare concrete).
Do not apply to cold surfaces.
Do not apply to freshly painted walls
(please wait at least two weeks).
Do not use a squeegee (or anything else besides
your hands!) to apply wall stickers.
Troubleshooting
What to do if you see air pockets forming during installation:
pull back a small section and reapply the wall sticker.
What to do if air pockets show after installation: poke a
hole in the air pocket with a safety pin, then atten out the
sticker.
Handle with Care
If you need to spot clean, use a dry wallpaper cleaner such
as Absorene Antique Wallpaper Cleaner and always test a
hidden spot rst.
Please do not use chemical cleaners.
If you are having any problems with the application procedure, please email us. Thank you for your purchase!
All rights reserved.

Summary of content (2 pages)