Specifications

Troubleshooting Symptom Charts/System - 8
Flashing ? appears at
startup in system
with 1.2 GB hard
drive, and is
corrected with a
restart.
1 Be sure system software is not corrupted. See the Software
Troubleshooting document in the HW-SW Procedures topic
under the Troubleshooting tab on the Service Source CD
startup screen.
2 Remove the 1.2 GB hard drive and look at the serial number.
The serial number is on a white label under the bar code, and
follows this line of print: 1.2GB, LAPZA, 655-0397
3 If the serial number does not end with a “C” replace the 1.2
GB hard drive under the Apple Limited Warranty.
Flashing ? appears at
startup in 6360 with
1.6 GB ATA hard drive
(p/n 661-1107),
and may be corrected
with restart.
1 Be sure system software is not corrupted. See the Software
Troubleshooting document in the HW-SW Procedures topic
under the Troubleshooting tab on the Service Source CD
startup screen.
2 Remove the 1.6 GB ATA hard drive and look at the serial
number on the bar code label.
3 If serial number is within range XXX XXXXX to
XXX XXXXX, replace hard drive.