User's Manual

3
1 Introduction
The Location Bridge device is designed for scanning in high density
2.4GHz environments. The Location Bridge enables robust indoor asset
tracking, including intelligent edge processing for efficient, fast,
and accurate location reporting.
2. Safety Recommendations
Do not disassemble, dismantle, open, crush or shred the product.
If the product envelope is weakened or broken, stop using it immediately.
Do not attempt to short-circuit the product or make contact with a conductive
object.
Do not expose the product to heat, fire or flame.
The device should not be installed and operated closer than 8 inches to a
person.
Keep out of reach of children.
After use, you must dispose of the product in compliance with applicable laws.
Failure to follow these instructions can result in personal injury or property damage, and
Manufacturer will have no liability whatsoever for any such injury or damage arising from or in
connection with any failure to follow these or other instructions provided to the end user.
Le non-respect de ces instructions peut entraîner des blessures corporelles ou des dommages
matériels, et Fabricant décline toute responsabilité en cas de blessure ou de dommage résultant
de ou en relation avec le non-respect de ces instructions ou d'autres instructions fournies à
l'utilisateur final.
3. Regulatory Notices
This equipment complies with FCC/IC radiation exposure limits set forth for
an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Operation of this device is restricted to indoor use only.