Location Bridge User Manual
Contents 1 Introduction ..........................................................................................................................................................3 2. Safety Recommendations ..........................................................................................................................................3 3. Regulatory Notices...............................................................................................................................................
1 Introduction The Location Bridge device is designed for scanning in high density 2.4GHz environments. The Location Bridge enables robust indoor asset tracking, including intelligent edge processing for efficient, fast, and accurate location reporting. 2. Safety Recommendations Do not disassemble, dismantle, open, crush or shred the product. If the product envelope is weakened or broken, stop using it immediately. Do not attempt to short-circuit the product or make contact with a conductive object.
3.1 Compliance with 47 CFR Part 15 Regulation Class B Devices This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. Son exploitation est autorisée aux deux conditions suivantes: —il ne doit pas produire de brouillage; et —il doit accepter tout brouillage radioélectrique subi, même si celuici est susceptible d’en compromettre le fonctionnement. 4.
The DEVEUI and AT (Activation Token) are necessary to provision the device on the LoRaWAN network. This information is encoded in the QR code. Do not remove the sticker or other proprietary notices or logos affixed to the device. Ne retirez pas l'autocollant ou d'autres mentions de propriété ou logos apposés sur l'appareil. 4.
Features Description Temperature measurement sensor accuracy +/- 1°C Temperature Range: -40°C to + 60°C Precision: +/- 1°C Humidity Absolute accuracy tolerance: +/- 3 %RH over 20..80%RH at 25°C 5 Installing the Bridge The product is designed to be installed in almost any enviroment, some of which include; Offices, hallways, closets, kitchens, bathrooms. The Bridge should be mounted to the ceiling using the mounting bracket. And included accessories. 5.1 Power Source 1.
3. Proceed with activation process through Asset Track app (Step 4) NOTE: If final Bridge in chain, Installer must ensure that jumpers are set 5.4 Activation 1. Using Asset Track software, a. Identify Room b. Identify Bridge Installation Location on floor plan c. Scan Bridge QR code or manually enter Bridge ID d. Confirm successful Bridge / Location pairing by pressing SUBMIT 5.
5.7 Button & LED Behavior LED Blink Rate: - - - - - - - - - - Fast Blink (0.2 seconds each) Unrecoverable activity Slow Blink (1.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Industry Canada statement This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
