Hardware manual

Startup, Shutdown and Status 3
Agilent 7500 Series ICP-MS Hardware Manual 3-15
2 Select Meters>>Meter Control Panel.
The Meters panel appears (Figure 25).
Figure 25 Meters Panel (Picture may differ depending on ICP-MS Model/Mode)
3 Select up to five components to monitor by clicking the appropriate
check boxes and then clicking OK.
Meter boxes for the selected components appear on the right side of the
screen. Check the following table to ensure that values displayed are within
acceptable limits.
NOTE
A delay in displaying the value on the meter in the can occur due to processing time
required by PC.
NOTE
Meter boxes are displayed until you close them individually or close the Instrument Control
window. Meter boxes that are open when the Instrument Control window is closed will
redisplay when this window is reopened.