Hardware manual

Maintenance 4
Agilent 7500 Series ICP-MS Hardware Manual 4-153
To perform the basic maintenance test, complete the following steps:
1 If completely shut down, restart the instrument.
See Chapter 3, “Startup, Shutdown and Status” in this manual.
2 Check the status of the instrument meters.
See Chapter 3, “Startup, Shutdown and Status” in this manual.
3 Change the instrument to Analysis mode.
See Chapter 3, “Startup, Shutdown and Status” in this manual.
4 Tune the instrument.
Refer to chapter 1 ‘Tuning’ in the Agilent 7500 Series ICP- MS Tuning and
Application Handbook.
5 Run a standard solution and examine the results.
Refer to the Agilent 7500 ICP- MS MassHunter Workstation Operator's
Manual (or ChemStation Operator's Manual).