Hardware manual

Maintenance 4
Agilent 7500 Series ICP-MS Hardware Manual 4-63
Assembling the Torch, Shield Plate, and Bonnet
To assemble the torch, the shield plate, and the bonnet, complete the following
steps:
1 Insert the torch into the shield plate.
Insert the torch into the shield plate. Adjust the projection of the torch into
the hole of the shield plate.
Figure 63 Torch, Shield Plate and Bonnet
2 Insert the torch and the shield plate into the bonnet.
Insert the assembled torch and shield plate into the bonnet until the bonnet
touches the projection of the torch.
Projection for Shield Plate
Projection for
Torch Stand
Hole
Shield Plate
Bonnet
Tor ch
CAUTION
Ensure that the bonnet direction is correct. The brim of bonnet is set on left side.