Hardware manual

F-4 Agilent 7500 Series ICP-MS Hardware Manual
Figures
Figure 82. Reaction Cell Assembly 4-102
Figure 83. Reaction Cell as Refitted 4-103
Figure 84. Plate Bias Wire 4-104
Figure 85. Reaction Cell Assembly Dismantled 4-105
Figure 86. Removing the Cell Entrance Lens 4-106
Figure 87. Securing the Octopole Plate 4-107
Figure 88. Removing the Cell Exit Lens 4-107
Figure 89. The Octopole with the Cell Entrance Lens and Cell Exit
Lens Removed 4-108
Figure 90. Plate Bias Lens Location (with the Reaction Cell
Assembly Removed) 4-109
Figure 91. Plate Bias Lens 4-110
Figure 92. Example of Rolling the Polishing Paper into a
Cone 4-111
Figure 93. Reaction cell assembly 4-117
Figure 94. Reaction cell and cell assembly screws 4-118
Figure 95. Plate Bias Wires 4-119
Figure 96. Checking the continuity (Cell Lower Block and Connector
Electrodes) 4-119
Figure 97. Checking the continuity (connector and individual
electrodes) 4-120
Figure 98. Checking the electrical connections 4-120
Figure 99. Installing the Reaction cell assembly 4-121
Figure 100. Expanded View of the Extraction Lens-Omega Lens
Assembly (7500cx) 4-122
Figure 101. Expanded View of the Extraction Lens-Omega Lens
Assembly (7500cs) 4-123
Figure 102. Hardware Settings dialog box (example for
7500cx) 4-124
Figure 103. Change Ion Lens Type dialog box 4-125
Figure 104. Octopole Setup dialog box 4-126
Figure 105. Reaction Gas Line Maintenance dialog box 4-127
Figure 106. EM and EM Cover 4-130
Figure 107. EM 4-131