Hardware manual

Agilent 7500 Series ICP-MS Hardware Manual F-3
Figures
Figure 55. PFA Concentric Nebulizer 4-44
Figure 56. Nebulizer Orientation 4-47
Figure 57. End Cap Orientation (example: Babington
Nebulizer) 4-49
Figure 58. ICP Torch 4-53
Figure 59. ICP Torch 4-54
Figure 60. Position of Torch Inside Work Coil 4-56
Figure 61. 4-58
Figure 62. Torch, Shield Plate and Bonnet 4-61
Figure 63. Torch, Shield Plate and Bonnet 4-63
Figure 64. Position of Torch Inside Work Coil 4-64
Figure 65. Shield Plate installation 4-65
Figure 66. Sample Introduction Maintenance Dialog Box 4-68
Figure 67. Removing the Sampling Cone 4-69
Figure 68. Removing the Skimmer Cone 4-70
Figure 69. Sampling Cone and Interface Alignment Mark 4-73
Figure 70. Vent Valve 4-78
Figure 71. Interface Cones and Extraction Lenses 4-80
Figure 72. Expanded View of the Extraction Lenses 4-81
Figure 73. Einzel Lens - Omega Lens Assembly 4-82
Figure 74. Expanded View of Einzel Lens - Omega lens
assembly 4-84
Figure 75. Position of Plate Bias (after removing Einzel lens-Omega
lens assembly) 4-85
Figure 76. Plate Bias Lens 4-86
Figure 77. Vent Valve 4-94
Figure 78. Sampling Cone, Skimmer Cone and Extraction
Lens-Omega Lens Assembly (7500cx) 4-98
Figure 79. Sampling Cone, Skimmer Cone and Extraction
Lens-Omega Lens Assembly (7500cs) 4-99
Figure 80. Expanded View of the Extraction Lens-Omega Lens
Assembly (7500cx) 4-100
Figure 81. Expanded View of the Extraction Lens-Omega Lens
Assembly (7500cs) 4-101