User`s manual

3.4 Software Configuration
B. If you used item B in section Section 3.4.2 to enter the debug monitor, then
use this procedure to return to Windows NT ARC firmware.
1. Turn off the power to the EB164, insert the jumper from J1-25/26
(CONF11 on the module).
2. Turn on the power to the EB164. After the power-up diagnostics are
run, the ARC console boot menu appears on the graphics display.
If the ARC console boot menu does not appear, check the output of
COM1 for error messages and review your hardware configuration.
Starting and Using the EB164 3–11