User guide
Table Of Contents
- 1. VEX Field Control System Overview
- 2. Software Installation
- 3. Equipment Setup – VEXnet only Configuration
- 4. Equipment Setup – 75MHz VEX only Configuration
- 5. Equipment Setup – combined VEXnet and 75 MHz VEX Configuration
- 6. VEX Field Control Software Operation
- 7. Theory of Operation
- 8. Normal Operation
- 9. Debugging – General
- 10. Debugging – VEXnet robots
- 11. Debugging – 75 MHz robots
VEX Field Control System User Guide
11.13.2013 Rev B www.vexrobotics.com Page 6
6. VEX Field Control Software Operation
Open the VEX Field Control Software. If required, change the Autonomous Period and Operator
Control Period (time in seconds) to match the game requirements.
Press “START” to start the match.
The next screen shot shows a match that has finished the Autonomous Period and is ready to continue
with Operator (driver) Control Period. Press “RESUME” to continue the match.
The next screen shot shows a match that has completed. Press “START” to start a new match.