User manual

18
FRONT PANEL OPERATION
Parametric EQ (Speaker EQ)
Delay Line
Delay for each speaker Line. Especially for
compensating for speaker placement.
Range: 0 to 200ms
Limiter
A Limiter for each speaker line is available.
Correctly set the Limiter will prevent peaks from
damaging your speakers.
Threshold
Range: -40 to 0 dB
Sets the Threshold/activation point for the
Limiter.
EQ 1-4 Type: Gain Freq: Width/Slope:
Band 1 Hi Pass ±18 dB 20 Hz – 20 kHz 2nd order
Par EQ ±18 dB 20 Hz – 20 kHz 0,03 – 4 Oct
Band 2 Par EQ ±18 dB 20 Hz – 20 kHz 0,03 – 4 Oct
Band 3 Par EQ ±18 dB 20 Hz – 20 kHz 0,03 – 4 Oct
Band 4 Lo Pass ±18 dB 20 Hz – 20 kHz 2nd order
Par EQ ±18 dB 20 Hz – 20 kHz 0,03 – 4 Oct
Ratio
Range: Off to Infinity
Sets the amount of attenuation.
Attack
Range: 1 to 100ms
The Attack time is the time it takes for the
Limiter to reach the gain-reduction specified by
the Ratio parameter.
Release
Range: 100ms to 7 sec.
Sets the time it will take for the Limiter to
release the attenuation of the signal.
Output
Range: 6; 12; 18; 22dBu
It is important that the Controller Outputs are
correctly matched to the Input range of your
amplifier. Please refer to your amplifiers manual
for correct settings.
or
or