User manual
16
17
Passive mode Active mode
System conguration
For maximum exibility, all Mach CM speakers can run either passive, using the built-in crossover, or active/biamped
with direct drive of each transducer. The speakers are all set up as passive from the factory but can easily be switched
over to active mode at a later stage.
Active mode setup
Input LF 1+1-
Input HF 2+2-
While operating in active mode the connectors on
the terminal plate will work as shown below:
Passive mode setup
Input Speakon pin 1+1-
While operating in passive mode the connectors
on the terminal plate will work as shown below:
+-2
+-2
+-1
+-1
HF
LF
x-over
Terminal
In/Link
In/Link
+-2
+-2
+-1
+-1
HF
LF
Terminal
In/Link
In/Link
Jumper
Wires to
speakers
Jumper
Wires to
speakers
Note! Barrier strip on terminal
is not available in active mode