User manual

Connecting to amplier

The way you connect your C-range speakers to your amplier depends on the type of installation that you are

making and the type of amplier used.

Cables

To get the best possible performance from your C-range speaker, use high quality cable. Cables with high

capacitance, high inductance and high impedance have a strong negative inuence on sound quality as well as

amplier reliability.

Mach Speakers A/S recommend 2x4 mm (11 AWG) or 4x4 mm (11 AWG) Mach speaker cable. This is a professional

rubber cable that is waterproof, has low impedance, low inductance and low capacitance. It also has a low sulfur

content that ensures minimum cable oxidation. The cable is very soft and easy to wind. For recommended cable

lengths, please see table.

Recommended cable lengths (damping factor = 50)

Simple connection

The most basic type of connection is a direct connection from one channel on the amplier to one speaker. In

this case connect the [+] terminal on the amplier to the [+] terminal on the speaker and the [-] terminal on the

amplier to the [-] terminal on the speaker.

Cable size/load 8 ohms 4 ohms 2 ohms

1.5# (16 AWG) 15 m (50 ft.) 7.5 m (25 ft.) 4 m (13 ft.)

2.5# (14 AWG) 30 m (100 ft.) 15 m (50 ft.) 7.5 m (25 ft.)

4.0# (12 AWG) 60 m (200 ft.) 30 m (100 ft.) 15 m (50 ft.)

Output

Note! All congurations are

illustrated with one channel

Amplier

In/Link

Mains

In/Link