User guide

SECTION UA – UNLOADING AND SETUP
Form 169365 UA-7 Issue – May 2008
IV. BUMPER
a. Loosen eight nuts (A) on bumper clamps.
b. Slide bumper (B) to specified location (see
previous page).
c. Re-tighten nuts. Ensure nuts are evenly
tightened.
V. FRONT AND REAR SUPPORTS – TWO &
THREE AXLE
a. Loosen four bolts (C) on support (D).
b. Slide support to desired location and retighten
bolts. Ensure supports are evenly clamped onto
main beam.
FRONT SUPPORT SHOWN – REAR SUPPORT SIMILAR
C
D
B
A