Instruction Manual

OPERATION
Removing Crop Divider Rods
To remove divider rods, follow these steps:
1. Loosen bolt (B) and remove rod (A).
Figure 4.56: Crop Divider Rod
2. Store both rods on the inboard side of the
right endsheet.
Figure 4.57: Stored Divider Rod
UsingRiceDividers
Optional special rice dividers can be installed and used
when required. Refer to 8.4.13 Rice Divider Rods, page
269.
The installation and removal procedures are the same as
for the standard crop dividers.
Fig
ure 4.58: Divider Rod for Rice
169899 73 Revision A