Instruction Manual

OPERATION
Removing Crop Dividers from Hea der without Latch Option
To remove crop dividers from a header without the latch option, follow these steps.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. Refer to the windrower
operator’s manual for instructions regarding the proper use and storage of header safety props.
1. Lower reel, raise header, stop engine, remove key, and engage safety props. For instructions, refer to your
windrower operator’s manual.
2. Open/remove header endshields. Refer to 4.2.3 Endshields, page 37.
3. Remove bolt (A), lock washer and flat wa sh er.
4. Lower divider (B) and lift off endsheet.
5. Close/replace header endshields. Refer to 4.2.3
Endshields, page 37.
Figure 4.50: Crop Divider
Installing Crop Dividers on Header with La tch Option
To install crop dividers on a header with the latch option, follow these steps.
DANGER
To avoid
bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove k
ey, and engage safety props before going under header for any reason. Refer to the windrower
operato
r’s manual for instructions regarding the proper use and storage of header safety props.
1. Lower reel, raise header, stop engine, remove key, and engage safety props. For instructions, refer to your
windrower operator’s manual.
2. Open header and remove endshields.
169899 69 Revision A