Instruction Manual

OPERATION
Reposition left arm cylinder as follows:
NOTE:
Reel components are not shown for clarity.
9. Re mo ve pin (A)
securing cylinder (B) t o bracket/light
assembly (C).
10. Remove bolts
(D) securing b racket (C) to reel arm and
remove brac k
et/light assembly.
11. If necessary
, remove c able tie securing harness to
bracket or r
eel arm.
12. Swivel ligh
t to working position as shown.
Figure 4.
40: Forward Position
13. Reposition b racket/light asse mbly (C) on reel arm as
shown and reinstall the four bolts (D) to secure bracket
to reel arm. Tighten bolts.
14. Push reel back and reinstall cylinder (B) to bracket with
pin (A). Secure pin with co tter pin.
15. Secure light harness to bracket with plastic tie wrap.
16. Check reel clearance to backsheet, upper cross auger
(if installed) and reel braces.
17. Adjust reel tine pitch (if required). For adjustment
procedures, refer to 4.7.10 Reel Tine Pitch, page 65.
Figure 4.41: Rearward Position
169899 64 Revision A