Instruction Manual

OPERATION
A decal (A) is provided on the reel right support arm for
identifying reel position. The cam disc aft edge (B) is the
gauge indicator.
For straight standing crop, center the reel over the cutterbar
(4–5 on decal).
For crops that are down, tangled, or leaning, it may be
necessary to move the reel ahead of the cutterbar (lower
number on decal).
IMPORTANT:
When difficulty is encountered picking up flattened crop,
adjust header angle to a steeper position. Refer to
Controlling He ader Angle, pa ge 56 for adjustment details.
Adjust reel position only if header angle adjustments are
not sat isfa ct ory.
Refer to 4.6.2 Header Settings, page 46 for recommended
reel positions in specific crops and crop conditions.
Figure 4.31: Fore-Aft Decal
Adjusting R eel Fo
re-Aft Position
To adjust the reel fore-aft position, follow these steps:
1. Select FORE-AFT mode on the selector switch in the cab.
2. Operate the hydraulics to move the reel to the desired position, again using the gauge as a reference.
3. Check reel clearance to cutterbar after making changes to cam setting. Refer to the following for measurements
and adjustment procedures:
• 6.8.1 Reel Clearance to Cutterbar, page 200
• 6.8.2 Reel Frown, page 203.
IMPORTANT:
Operating wit
h the reel too far forward can cause the fingers to contact the ground. Lower the skid shoes or adjust
header tilt as
required when operating with the reel in this position to prevent damage to the fingers.
Repositioning Fore-Aft Cylinders on Single Reel
The reel can be moved approximately 9 in. (227 mm) further aft by repositioning the fore-aft cylinders on the reel
arms.
WARNING
Stop windrower engine and remove key before making adjustments to machine. A child or even a pet could
engage the drive.
169899 59 Revision A