Instruction Manual

OPERATION
IMPORTANT:
Continuous operation with excessive spring compres sion
(i.e., load Indicator reading greater than ‘4’ora
compressed length (A) less than 11–5/8 in. [295 mm])
can result in damage to suspension s ystem.
14. Adjust header angle to desired working angle with the
machine’s he ader angle controls. If angle is not critical,
set it to mid-position.
NOTE:
The height se
nsor on the CA25 adapter must be
connected t
o the combine header control module in the
cab.
15. Use the windrower cab display module (CDM) controls
to automatically maintain cutting height. Refer to your
windrower operator’s manual for details.
Figure 4.22: Spring Compression
Adjusting Stabi lizer W heels
The proper setting requires balancing the amount of header weight carried by the floa t and the stabilizer wheels.
1. Raise the he ader so that the stabilizer wheels are off
the g round. Shut down engine and remove the key.
2. Check that the float is working properly. See your
windrower operator’s manual for instructions.
CAUTION
Handle may be under tension, especially when
the wheels are on the ground. Raise header so
that wheels ar e off th e ground before making
adjustments.
3. Support wheel weight by lifting slightly with one hand
on handle (B). Pull up on handle (A) to release lock.
4. Lift wheel with handle (B) and engage support channel
into center slot (C) in upper support.
5. Push down on handle (A) to lock.
Figure 4.23: Stabilizer Wheel
169899 52 Revision A