Instruction Manual

OPERATION
Installing Endshields
To install an endshield, follow these steps.
1. Position endshield on support (A) and align the hole in
the endshield with stud (B) on the support.
Figure 4.14: Endshield
2. Sec ure e
ndshield to the support with acorn nut (A).
3. Close en
dshield. Refer to Closing Endshields, page
38.
NOTE:
Plastic endshields are subject to expansion, or
contraction depending on large temperature variations.
Top pin and lower latch bracket positions can be adjusted
to compensate for dimensional changes. Refer to
Adjusting Endshields, page 41.
Figure 4.15: Endshield
169899 40 Revision A