Instruction Manual

OPERATION
2. Use tool (B) to unlock latch (A) at lowe r r ea r c orne r
of endshield.
3. Lift shield at aft end to clear pin at top rear of endshield.
4. Swing shield out and away from header while
maintaining forward pressure to prevent shield from
slipping out of tab (C) at front o f endsheet.
IMPORTANT:
Do NOT force shield once it has reached its end of travel,
as damage to the shield structure can occur. Shield is
designed to open sufficiently for normal access to the
drive system and manual case as shown.
Figure 4.8: Endshield
NOTE:
If more access is required to the front of the drives area,
carefully disengage front of shield from tab at the front
of the endsheet and then swing front of the shield away
from the header.
NOTE:
If comple
te access to the endsheet area is required, the
shield ca
n be removed. Refer to Removing Endshields,
page 39.
Figure 4.9: Endshield Open
Closing Endshields
To clos
e an endshield, follow these steps.
1. Maint
ain forward pressure and swing rear of shield
towar
ds header.
2. Lift s
hield and engage pin (C) on top of frame endsheet.
Figure 4.10: Endshield
169899 38 Revision A