Instruction Manual

MAINTENANCE AND SERVICING
Replacing Ch ain on Single Reel
1. Lift chain (A) off drive sprocket (B).
2. Lower chain until free of lower sprocket (C) and remove
chain from drive.
3. Locate new chain (A) around bottom teeth on lower
sprocket (C).
4. Lift chain onto drive sprocket (B) ensuring all links are
properly engaged in teeth.
Figure 6.2
52: Reel Drive
Tightenin
g Drive Chain
1. Ensure the six bolts (B) securing motor mount to chain
case are loose.
2. Slide motor and motor mount upwards until chain (A)
is tight, and tighten bolts (nuts on backside).
3. There s hould be 1/8 in. (3 mm) of slack in the chain.
Adjust if necessary.
4. Torque bolts (B) to 54 lbf·ft (73 N·m).
Figure 6.253: Reel Drive
Installing Drive Cover
Install reel drive cover as follows:
1. For SINGLE REEL DRIVE, position reel drive cover (A)
to th e reel drive an d secure with four bolts (B) .
Fig
ure 6.254: Single R eel Drive Cover
169899 239 Revision A