Instruction Manual

MAINTENANCE AND SERVICING
10. Remove temporary reel support.
11. Proceed to Tightening Drive Chain.
Figure 6.244: Supporting Reel
Breaking the Chain Method
1. Grind off head of a link rivet on chain (A), punch out the
rivet, and remove chain.
2. Grind off the head from one of th e link r ivets on the new
chain and punch out rivet to separate the chain.
3. Locate ends of chain on sp r ocket (B).
Figure
6.245: Reel Drive
4. Install pin connector (A) (not available as a MacDon
part) into chain, preferably from sprocket backside.
5. Install connector (B) onto pins.
6. Install spring clip (C) onto front pin (D) with closed end
of clip in direction of sprocket rotation.
7. Locate one leg of clip in groove of apt pin (E).
8. Press oth er leg of s pring clip over face of aft pin (E)
until it slips into groove. Do NOT press clip lengthwise
from closed end.
9. Ensure clip is seated in grooves of pins.
Fig
ure 6.246: Chain
169899 236 Revision A