Instruction Manual

MAINTENANCE AND SERVICING
3. Remove six bolts (A) attaching U -joint flange (B) to
driven sprocket (C).
4. Remove U-joint.
NOTE:
Right hand reel may need to be moved sideways for
U-joint to clear reel tube.
Figure 6.219: U-Joint
Installing Do uble Reel U-Join t
To install
the U-joint, follow these steps.
NOTE:
Right hand reel may need to be moved sideways for
U-joint to clear reel tube.
1. Position
U-joint flange (B) onto driven sprocket (C) as
shown. I
nstall six bolts (A) and hand-tighten. Do NOT
torque a
t this time.
Figure 6.220: U-Joint
2. Position right-hand reel tube against reel drive and
engage stub shaft into U-joint pilot hole.
3. Rotate reel until holes in end of reel tube and U-joint
flange (B) line up.
4. Install four bolts (A) and t orque to 70–80 ft· lbf
(95–108 N·m).
Figure 6.221: U-Joint
169899 226 Revision A