Instruction Manual

MAINTENANCE AND SERVICING

Installing Drive Sprocket

1. Install the new drive s procket (D), ﬂ at washer (C), and

slotted nut (B), onto the motor shaft.

2. Torque nut to 40 lbf·ft ( 54 N·m). Tighten to next slot if

necessary to install cotter pin (A).

Figure 6.2

11: Reel Drive Sprocket

3. In st all the chain (A) onto drive sprocket (B).

Figure 6

.212: Reel Drive

Tighte

ning Drive Chain

1. Ensure the six bolts (B) securing motor mount to chain

case are loose.

2. Slide motor and motor mount upwards until chain (A)

is tight, and tighten bolts (nuts on backside).

3. There s hould be 1/8 in. (3 mm) of slack in the chain.

Adjust if necessary.

4. Torque bolts (B) to 54 lbf·ft (73 N·m).

Figure 6.213: Reel Drive

169899 223 Revision A