Instruction Manual

MAINTENANCE AND SERVICING
6. Move endshield (A) away from support (B), and place
new endshield (C) onto s upports.
7. Reattach end of endshield (A) to support (B).
8. Reinstall bolts (D).
9. Tighten all hardware.
Figure 6.203: Endshields
Replacing Support
1. Lower head
er and reel, and shut down engine. Remove key from ignition.
2. Manually
rotate reel for access to endshield support (A)
to be repl
aced.
3. Remove bo
lt (B) from support (A).
4. Remove bo
lts (C) from support (A) and two
adjacen
t supports.
Figure 6.204: Endshield Supports
5. Move en
dshields (A) away from tine tube and rotate
suppo
rt (B) towards reel to remove it.
6. Inser
t tabs of new support (B) into slots in endshields
and ro
tate into endshields. Ensure tabs engage
both e
ndshields.
7. Secu
re support (B) to disc with bolt (C) and nut. Do
not t
ighten.
8. Secu
re endshields (A) to support (B) with bolt (C) and
nut.
Do not tighten.
9. Re a
ttach supports with bolts (C) and nuts.
10. Che
ck clearance between tine tube and endshield
sup
port, and adjust if necessary.
11. Tor
que nuts to 20 ft·lbf (27 N·m).
Figure 6.205: Endshield Supports
169899 220 Revision A