Instruction Manual

MAINTENANCE AND SERVICING
NOTE:
A pair of m odified channel lock pliers is recommended
to install the b us hing clam p s. Secure pliers (A) in v ice
and grind in a notch (B) at the end of each arm that fits
the clamp (C).
Figure 6.183
Cam End Bushings
1. Position bushing halves (B) on tine tube with flangeless
end adjacent to reel arm, and locate lug in each
bushinghalfinholeintinetube.
2. Slide tine tube (A) toward tail end of reel to insert the
bushing (B) into the reel arm. If tine tube supports are
installed, ensure that the bushings at those locations
slide into the support.
3. Re-install finge rs or tines if removed. Refer to:
• Install
ing Steel Tines, page 205
• Install
ing Plastic Fingers, page 207
Figure 6
.184: Cam End
4. Install bushing clamp (A) onto t ine tube adjac ent to
flangeless end of bushing (B).
5. Position clamp (A) on bushings (B) so that edges
of clamp and bushing are flush when clamp fits into
groove on bushing and lock tabs are engaged.
Figu
re 6.185: Bushing
169899 213 Revision A