Instruction Manual

MAINTENANCE AND SERVICING
10. Remove bolt (A) at on cam linkage so that tine t ub e (B)
is free to rotate.
Figure 6.175: Cam End
11. Re lease bu shing cla mps (A) at the cam discwit h a
small screwdriver to separate the serrations. Move
clamps off bushings.
Figure 6.176: Bushing Clamp
12. Slide tine tube (A) outboard to expose the bushing.
Remove the bushing halves (B). If required remove the
next tine or plastic finger, so that the arm can slide off
the bushing. Refer to:
• Removing Plastic Fingers, page 206
• Removing Steel Tines, page 205
Figure 6.177: Cam End
169899 210 Revision A