Instruction Manual

MAINTENANCE AND SERVICING
Cam End Bushings
NOTE:
Removing cam en
d b ushings requires that the tine tube
be moved throu
gh the disc arms to expose the bushing.
6. At the cam end, remove endshields and endshield
support (A) at applicable tine tube location on the
cam end.
Figure 6.172: Cam End
7. At the tail end, remove reel endshields and endshield
support (C) at applicable tine tube location.
NOTE:
There are n
o end shields on the center discs.
8. At the tai
l and center discs, remove bolts (A) securing
arm (B) to
disc.
Figure 6.173: Tail End
9. At the t
ine tube support (if installed) locations ,either
releas
e the bushing clamps or disconnect the support
channe
ls from the tube support, depending on which
tine tu
be is being moved. Th ree tine tubes (B) require
that t
he channels be disconnected and two (C) require
only t
o remove the bushing clamp.
Figure 6.174: Tine Tube Supports
169899 209 Revision A