Instruction Manual

MAINTENANCE AND SERVICING
2. Remove reel endshields and endshield support (C)
from the tail end of the reel at applicable tine
tube location.
NOTE:
There are no en
dshields on the center disc.
3. Remove bolts
(A) securing arm (B) to disc.
IMPORTANT:
Note the hole locations in arm and disc and ensure bolts
are reinstalled at original locations.
Figure 6.169: Tail End
4. Release bushing clamps (A) using a s mall screwdriver
to separate the serrations. Pull clamp off tine tube.
Figure 6.170: Bushing Clamp
5. Rotate arm (A) clear of disc and slide arm inboard off
bushing and remove bushing halves (B). If required
remove the nex t tine or plastic finger, s o that the arm
can slide off the bushing. Refer to:
• Removing Plastic Fingers, page 206
• Removing Steel Tines, page 205
Figure 6.171: Bushing
169899 208 Revision A