Instruction Manual

MAINTENANCE AND SERVICING
3. Adjust the profile as follows: Start with the ree l disc set
closest to center of header and proceed to the ends.
a. Re move bolts (A).
b. Loosen bolt (B) and adjust arm (C) until desired
measurement is obtained between reel tube
and cutterbar.
NOTE:
Allow the reel tubes to find a natural curve and
position the hardware a ppropriately.
c. Reinstall bolts (A) in aligned holes and tighten.
Figure 6.160: Reel A rm
6.8.3 Centering the Reel
The reel(s
) should be centered between the endsheets.
Centerin
g D ouble Reels
To center the reels, follow these steps:
1. Loosen bolt (A) on each brace (B).
2. Move forward end of reel center sup p ort arm ( C)
laterally as required to center both reels.
3. Tighten bolts (A) and torque to 265 ft·lbf (359 N·m).
Figure 6.161: Centering Reel
169899 204 Revision A