Instruction Manual

MAINTENANCE AND SERVICING
4. Open endshield.
5. Position forward deflector (B) onto endsheet and
temporarily install forward and aft 3/8 in. x 5/8 self
tapping screws (A).
6. Check fit of forward end of deflector onto cutterbar.
There should be no gap between deflector and
cutterbar. Remove and bend deflector as required to
obtain best fit.
7. Install the four 3/8 in. x 5/8 self-tapping screws (A) and
tighten.
Figure 6.150: Forward Deflector
8. Position aft deflector (C) as shown and install three 3/8
in. x 3/4 carriage bolts (B) and lock nuts. Orientation
of bolts not important.
9. Install two Torx® head screws (A) and lock nuts with
heads facing down.
10. Tighten all fasteners.
11. Repeat above steps for opposite end.
Figure 6.151: Aft Deflector
169899 199 Revision A