Instruction Manual

MAINTENANCE AND SERVICING
Removing Narrow Draper Deflectors
To remove narrrow draper deflectors, follow these steps: Left end removal is illustrated .
1. Raise reel fully and lower header to ground.
2. Shift decks to allow work space at one end of header if hydraulic deck shift installed, otherwise move decks
manually after shutting down windrower.
3. Stop engine, remove key, and engage reel safety props.
4. Open endshield.
5. Remove the two To rx ® head screws (A) and lock nuts.
6. Remove the three carria ge bolts (B) and lock n ut s an d
remov e aft de flector (C).
Figure 6.
148: Aft Deflector
7. Remove the four screws (A) and re m ove deflector (B).
8. Repeat above steps for opposite end.
Figur
e 6.149: Forward Deflector
Insta
lling Narrow Draper Deflectors
Narrow deflectors can replace wide d eflectors if bunching occurs at the ends of the header when decks are set
for center delivery.
To install narrrow draper deflectors, follow these steps: Left end ins ta llation is illustrated.
1. Raise reel fully and lower header to ground.
2. Shift decks to allow work space at one end of header if hydraulic deck shift installed, otherwise move decks
manually after shutting down windrower.
3. Stop engine, remove key, and engage reel safety props.
169899 198 Revision A