Instruction Manual

MAINTENANCE AND SERVICING
6. Remove fasteners securing deflector to endsheet.
Nuts (A) are accessible from endshield side. Nuts (B)
on uppermost fasteners are accessible from behind
the deflector (C).
7. Re mo ve the deflector (C).
Figure 6.143: Wide Deflector
8. Remove bolts (A) and remove deflector support (B).
9. If support (B) will not be re-installed, replace lower
bolt (B) that holds belt guide (C) on opposite side of
endsheet.
10. Repeat above steps for opposite end.
Figure 6.144: Deflector S upport
Installing Wide Draper Deflectors
To inst
all draper deflector, follow these steps: Left installation is illustrated.
1. Raise r
eel fully and lower header to ground.
2. Shift
decks to allow work space at one end of header if hydraulic deck shift installed, otherwise move decks
manua
lly after shutting down windrow er.
3. Stop e
ngine, remove key, and engage reel safety props.
169899 196 Revision A