Instruction Manual

MAINTENANCE AND SERVICING

Installin g Draper Idler Roller

1. Position stub shaft in idler roller in forward arm (B) on

deck.

2. Push on roller to deﬂect f orward arm s lightly so that

stub shaft at rear of roller can be slipped into rear arm

(C).

3. Install bolts (A) with washers, and torque to 70 lb-ft

(93 N·m).

4. Wrap the draper over the idler roller, re-connect it and

set the tension. See 6.7.2 I nstalling Drapers, pa ge 176.

5. Run machine to verify that draper tracks correctly.

Adjust tracking if required. See 6. 7.6 Adju sting H eader

Draper Tracking, page 184.

Figure 6.1

31: Idler Roller

Draper Drive Roller

Removing Draper Drive Roller

1. If draper connector is not visible, engage the header until the connector is accessible, preferably close to the

outboard end of the deck.

DANGER

Engage header safety props and reel props before working under header or reel.

2. Raise header and reel, shutdown the engine.

3. Engage header lift cylinder safety props and reel lift cylinder safety props.

4. Loosen draper by turning adjuster bolt (A)

counterclockwise.

Figure 6.132: Tensioner

169899 191 Revision A