Instruction Manual

MAINTENANCE AND SERVICING
5. Set deck (A) to 5/16–3/8 in. (8–9 mm) below the
cutterbar (C) to create a seal.
6. Tighten deck support hardware (D).
7. Check dimension (B) again it should be set to
5/16–3/8 in. (8–9 mm).
8. Tension draper. Refer to 6.7.3 Adjusting Draper
Tension, page 178.
Figure 6.123: Deck Support
9. Adjust the backsheet deflector (A). Loosen nut (D)
and adjust deflector (A) until there is a 0.04–0.3 in.
(1–7 mm) gap (C) between the draper (B) and the
deflector (A).
Figure 6.124: Backsheet Deflector
169899 187 Revision A