Instruction Manual

MAINTENANCE AND SERVICING
3. Adjust the drive roller at ‘X’ as follows:
a. Loosen nuts (A) and jam nut (B).
b. Turn adjuster nut (C).
Figure 6.119: Drive Roller
4. Adjust the idler roller ‘Y’ as follows:
a. Loosen nut (A) and jam nut (B).
b. Turn adjuster nut (C).
5. If the draper does not track at the idler roller end after
adjusting the idler r olle r, the drive roller is likely not
square to the deck. Adjust the drive roller, and then
readjust the idler roller.
Figure 6.120: Idler Roller
169899 185 Revision A