Instruction Manual

MAINTENANCE AND SERVICING
6.7.5 Installing Endless Draper
To install an e
ndless draper, follow these steps:
DANGER
To avoid bodily injury or death from unexpected
start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going
under header for any reason. Refer to the windrower
operator’s manual for instructions regarding the
proper use and storage of header safety props.
1. Insert a pry bar (A) through draper and locate bar
in hole in deck located at approximately the deck
mid-point.
NOTE:
Pry bar should be sufficient length to
accommodate width of draper.
2. Lift deck clear of cutterbar and support bar on a
stand (B) of suitable height.
3. Slide draper onto deck.
Figure 6.115: Supporting the Draper
4. Lift deck, remove stand (B), and lower deck into
position. Remove pry bar (A).
Figure 6.116: Lifting the Deck
169899 183 Revision A