Instruction Manual

MAINTENANCE AND SERVICING
NOTE:
The following two steps are not applicable to the right
side drive.
4. Loosen two bolts (A) on endsheet.
5. Turn adjuster bolt (B) to loosen the two V-belts (C) and
remov e them.
Figure 6.79: Knife Drive V-Belts
6. Open the access panel (A) inside the draper opening,
just behind cutterbar. This will give you access to the
knife drive pulley.
7. Remove the knife drive belt.
Figure 6.80: Access Cover
Installing Timed Knife Drive Belt
This pr
ocedure is applicable to the knife drive on both left and right sides.
If ther
e are problems with belt alignment. Refer to Adjusting Belt Tracking, page 172.
1. Route
knife drive belt (A) around knife drive pulley (B)
and kn
ife drive box pulley (C).
NOTE:
When installing belt, never pry belt over pulley.
Figure 6.81: Left Side – Right Side Similar
169899 166 Revision A