Instruction Manual

MAINTENANCE AND SERVICING
4. Open the access cover (A) on the endsheet behind
cutterbar to provide clearance between the knife drive
box pulley a nd the endsheet.
Figure 6.56: Access Cover
5. Manually stroke knife to its outer limit and clean area
around the knifehead.
6. Remove bolt (A).
7. Re move the greas e zerk (B) from the pin.
8. Use a screwdriver or a chisel in slot (C) to r elease load
on knifeh ead pin.
9. Pry pin upward with a screwdriver in pin groove u ntil
pin is clear of knifehead.
10. Push the knife assembly inboard until it is clear of the
output arm.
11. Seal bearing in knifehead with plastic or tape.
Figure 6.57: Knifehead
169899 156 Revision A