Instruction Manual

MAINTENANCE AND SERVICING

CAUTION

Wear heavy gloves when working around or handling knives.

3. Place knifehead shield (A) against end sheet as shown.

Orient the shield so that cutout matches proﬁle of

knifehead and/or hold-downs.

4. Bend shield along slit to conform to endsheet.

5. Align mounting holes and then install two 3/8 in. x 1/2

Torx

head bolts (B).

6. Snug up bolts just enough so that shield can be

adjusted as close as possible to the knifehead.

7. Manually rotate knife drive box pulley to move knife

and check for areas of contact between the knifehead

and shield.

8. If required, adjust shield to avoid interference with

the knife.

9. Tighten bolts.

Figure 6.48: Kn ifehead Shield

169899 152 Revision A