Instruction Manual

MAINTENANCE AND SERVICING

NOTE:

For ease of remo ving or installing kn ifehead p in, remove

grease zerk from pin.

2. Install knifehead pin (A) through the output arm and

into the knifehead.

3. Set groove (B) in knifehead pin 0.06 in. (1.5 mm)

above (C). Install the 5/8 in. x 3 hex head bolt and

nut(D)andtorqueto160ft·lbf (217 N·m).

Figure 6.33: Knifehead

4. Install grease zerk (A) into the knifehead pin, turn the

grease zerk for easy access.

Figure 6.34: Knifehead

6.5.6 S pare Knife

A spare knife may be stored in the header frame tube at

the left end. Ensure knife is secured in place.

Figu

re 6.35: Sp a re Knife

6.5

.7 Knife Guards

Check DAILY that guards are aligned and that knife sections are contacting shear surface of each guard.

169899

Revision A