Instruction Manual

MAINTENANCE AND SERVICING
To replace a section, follow these steps:
1. Stroke knife as required to center the section (A)
between guards.
2. Remove nuts (B).
3. Remove bars (C) and lift section off the knife bar.
4. Ifsectionisunderasplicebar(D),removethebar.
5. Clean any dirt off of knife back and position new section
on knife.
IMPORTANT:
Do NOT mix fine or coarse sections on same knife.
6. Reposition
bars (C) and/or (D) and install lock nuts (A).
NOTE:
Ifreplacingascrew,makesuretofullyinsertit.Donot
use the nut to draw the screw into the knife bar.
7. Torque nu ts to 7 ft·lbf (9.5 N·m).
Figure 6.29: Cutterbar
169899
1
41
Revision A