Instruction Manual

5 Header Attachment/Detachment
This chapter includes instructions on setting u p, attaching, and detaching the header.
5.1 Attaching Header to Windrower
Refer to your windrower operator’s manual for
procedures to mechanically attach the header to t he
self-propelled windrower.
Refer to the following procedures for electrical and
hydraulic connections.
Header drive hydraulic hoses and electrical harness are
located on the left cab -f orward side of the trac tor. The
reel drive and control hoses are located on the right
cab-forward side.
To attach the header to a windrower, follow these steps:
1. Before connecting header drive hydraulics (A) and
electrical harness (B) to header, check connectors and
clean if required.
Figure 5.1: Header Drive Hoses
2. Disengage and rotate lever (A) counterclockwise to
fully up po sition.
3. Remove cap (B) securing electrical connector to frame.
4. Move hose bundle (C) from windrower around hose
support on header.
Figure 5.2: Header Drive Hoses
169899 107 Revision A