Instruction Manual

OPERATION
4.16 Storage
The following should be done at the end of each operating season:
CAUTION
Never use gasoline, naphtha, or any volatile material for cleaning purposes. These materials may be toxic
or flammable.
CAUTION
Cover cutterbar and knife guards to prevent injury from accidental contact.
1. Clean header tho
roughly.
2. Store machine i
n a dry, protected place if possible. If stored outside, always cover with a waterproof canvas or
other protecti
ve m aterial.
NOTE:
If machine is stored outside, remove drapers and store in a dark, dry place. If drapers are not removed, store
header with cutterbar lowered so water/snow will not accumulate on drapers. This accumulation of weight puts
excessive stress on drapers and header.
3. Lower header o
nto blocks to keep cutterbar off the ground.
4. Lower reel com
pletely. If stored outside, tie reel to frame to prevent rotation caused by wind.
5. Re-paint all
worn or chipped painted surfaces to prevent rust.
6. Loosen drive
belts.
7. Lubricate h
eader thoroughly, leaving excess grease on fittings to keep moisture out of bearings. Apply grease
to exposed t
hreads, cylinder rods, and sliding surfaces of components. Oil knife components to prevent rust.
8. Check for wo
rn or broken components, and repair or order replacements from your MacDon Dealer. Attention
to these ite
ms right away will save time and effort at beginning of next season.
9. Replace or t
ighten an y missing or loose hardware.
169899 105 Revision A