Instruction Manual

OPERATION
11. Remove pin (A), raise support (B) to position shown,
and reinsert pin (A).
IMPORTANT:
Ensure pin (A) engages the tube on the axle.
12. Swing brace (C
) into position as shown and insert
brace into sl
ot (D) behind cutterbar. Position brace so
that pin (E) e
ngages hole in bracket (F). Right hand
wheel is now i
n Transport position.
13. Disengage th
e header cylinder lift stops.
14. Detach the h
eader from the windrower. Refer to your
windrower o
perator’s manual for procedure.
15. Detach the h
eader’s hydraulic and electrical
connectio
ns from the windrower. Refer to 5 Header
Attachmen
t/Detachment, page 107.
16. Start wind
rower and lower header to the ground.
Figure 4.
94: Positioning Right Rear Wheel
Attachi
ng Tow-Bar
The tow-bar consists of two sections which make storage and handling easier.
1. On the right side of the header, unhook rubber strap
(D)oncradle(A).
2. Remove clevis pin (C). Detach tube end from support
(B).
3. Replace clevis pin.
4. Lift inner half of tow-bar off of header, and place it near
the left side of the header.
Fi
gure 4.95: Removing Tow-Bar
169899 101 Revision A