User Manual

SECTION 6 OPERATION

169000 / 169040 78 Revision E

6.17.5.4 Reel Vertical Position: A40-D

a. Open LH endshield.

b. Loosen four nuts (E).

c. Loosen jam nuts on adjuster bolts (F), and turn

bolts (F) to raise or lower reel.

NOTE

Adjustment at forward adjuster bolt

should be 0.47 in. (12 mm) lower than at

rear adjuster bolt.

d. Tighten jam nuts.

e. Tighten four nuts (E).

f. Open RH endshield.

g. Loosen four nuts (G ).

h. Loosen jam nuts on adjuster bolts (H), and turn

bolts (H) to adjust reel vertical position.

i. Tighten jam nut.

j. Tighten four nuts (G).

k. Close shields before engaging header.

l. Check that the reel rotates freely.

IMPORTANT

Manually rotate reel, and ensure that tines

do not

contact header pan, otherwise

damage to pan will result.

If necessary, grind off excessive length

from tine if tine length varies co nsiderably.

Remove any sharp edges or burrs from

tine.

m. Check that reel is evenly adjusted.