User Manual

SECTION 6 OPERATION
169000 / 169040 37 Revision E
o. Open header LH driveshield.
p. Check hose routing at the reel motor. The hose
routing depends on which windrower model the
header is being attached to. The header is
factory-configured for M150, M155, and M200
windrowers.
q. Change hoses as follows if header is being
mounted on a M100, M105, or M205 windrower:
1. Disconnect hose (C) at tee (E).
2. Disconnect hose (D) at ree l motor.
3. Disconnect tee (E) at motor lower port and
relocate to upper port.
4. Connect hose (D) to tee (E).
5. Connect hose (C) to motor lower port.
FACTORY CONFIGURATION
M150
,
M155 AND M200
C
D
E
M100, M105, M205 CONFIGURATION
C
D
E