User Manual

SECTION 7 MAINTENANCE AND SERVICING
169000 / 169040 171 Revision E
l. Adjust roll timing. Refer to Section 6.17.12.2
Roll Timing and Alignment.
m. Clean off excess sealant from motor flange and
gearbox face.
n. Apply light coat of silicone to motor flange, and
position motor on gearbox as shown until
mounting holes are aligned, and pinion engages
gear in gearbox.
o. Install bolts removed in step b. (A) and washers,
and torque to 75 ft·lbf (102 N·m).
p. Re-connect hoses to mot o r.
q. Close all shields before operating machine.